Tab Content
  • Pappy's Avatar
    14 Hours Ago
    Pappy replied to a thread Time for a New Battery in Gen V
    Here is something that is quirky about my car, but I figured out how to make sure I am in hibernation mode. I enter the mode with the door closed. ...
    24 replies | 604 view(s)
  • Pappy's Avatar
    1 Day Ago
    Pappy replied to a thread New 765LT in Your Other Rides
    You need to go to Maple and Ash in Scottsdale. Last time I was there was room in Valet between a 720S and a Ferrari with bull horns on the hood. LOL
    25 replies | 225 view(s)
  • Pappy's Avatar
    2 Days Ago
    Pappy replied to a thread New 765LT in Your Other Rides
    Will it pass sound at AMP? Track tires? LOL Absolutely beautiful! Pappy
    25 replies | 225 view(s)
  • Pappy's Avatar
    4 Days Ago
    Pappy replied to a thread F40 Crashed yikes in General
    I suspect these cars' individual histories are carefully tracked by the entire Ferrari community. What is or is not on Carfax is probably irrelevant.
    15 replies | 351 view(s)
  • Pappy's Avatar
    6 Days Ago
    Pappy replied to a thread F40 Crashed yikes in General
    Sounds like a downshift and on the throttle just as he goes out of sight.
    15 replies | 351 view(s)
  • Pappy's Avatar
    1 Week Ago
    Pappy replied to a thread Time for a New Battery in Gen V
    I bought a factory MOP-BBV4F001AA battery last month in Phoenix. They said there were 2 left in PHX at that time. $257.00. This is battery #2 in...
    24 replies | 604 view(s)
  • Pappy's Avatar
    2 Weeks Ago
    Actually pretty easy to do. I needed a set of control arms for another race car project - special configuration - long with clearance for very deep...
    71 replies | 3280 view(s)
  • Pappy's Avatar
    2 Weeks Ago
    Pappy replied to a thread ACR E Brake Fade in Gen V
    Yeah, but are you sure you are using them hard enough to get any heat in them? LOL
    37 replies | 577 view(s)
  • Pappy's Avatar
    2 Weeks Ago
    Pappy replied to a thread New diffuser in Gen V
    Not necessarily true. The function and efficiency of a diffuser depends on the angle of divergence from the ground. Anything over about 6 Degrees...
    25 replies | 414 view(s)
  • Pappy's Avatar
    3 Weeks Ago
    Pappy replied to a thread My 2013 Viper GTS Auction in Gen V
    Post #7 above
    57 replies | 1927 view(s)
  • Pappy's Avatar
    3 Weeks Ago
    Pappy replied to a thread Do you track your genV in Gen V
    Bump stops? A little risky if it is bottoming while turning (drives the spring rate way up), but not a big deal if it is bottoming while going...
    216 replies | 5172 view(s)
  • Pappy's Avatar
    3 Weeks Ago
    What are your thoughts about future parts availability for the new Corvette Z06? One-of-a-kind dual overhead cam, flat plane crank motor that...
    81 replies | 2884 view(s)
  • Pappy's Avatar
    3 Weeks Ago
    Pappy replied to a thread V Rod Muscle in Your Other Rides
    Very nice! Really clean.
    12 replies | 153 view(s)
  • Pappy's Avatar
    3 Weeks Ago
    I have an association with a diesel shop that is a distributor for Petrol Canada. Their diesel oil is very high quality, and it is all imported from...
    81 replies | 2884 view(s)
  • Pappy's Avatar
    3 Weeks Ago
    Disappointing, but not the end of the world. I know we all want to keep our cars as original as possible, but down the road you may have to make a...
    81 replies | 2884 view(s)
  • Pappy's Avatar
    4 Weeks Ago
    Pappy replied to a thread Patina in Your Other Rides
    Very nice! I have had my eye on a '53 Caddy 2-door hardtop in very similar condition - at least on the outside. Lots of patina - even the same...
    12 replies | 658 view(s)
No More Results

3 Visitor Messages

  1. My 06 coupe w/10 spoke rim in 24 closed trailer is tight so what is best to tie dwn it has 3 inch d rings & smaller d rings father away frm my frame holes strap hits frt bumper skin & how to strap rear all new to me
  2. Yo pappy! New to the site and just saw the awesome thread on you installing the acr-e vents to the srt hood. Any chance I can PayPal you for the templates and some tips? Looking to do it to my srt hood ASAP! Sorry for contacting you like this but I couldn
  3. Hey sir, I saw the amazing work you did on an SRT hood to make some holes for the fender vents, and also saw you were a fellow pilot (Navy H60 driver) and in the aerospace industry. Just wanted to pick your brain if you had time in regard to the process, I am looking into having this done to my viper as well. Any info would be great, and thanks for your service sir!

    V/R,

    Tony
Showing Visitor Messages 1 to 3 of 3
About Pappy

Basic Information

Date of Birth
July 30, 1947 (74)
About Pappy
Biography:
Retired USAF Fighter Pilot. Track Junkie.
Location:
Las Vegas/Phoenix
Interests:
Developing, building, and driving track cars
Occupation:
Defense (Aerospace) Contractor

Signature


2000 Viper GTS (sold), 2016 Viper ACR-E
Drivers: 2011 Z06/Z07, 62 Corvette, 2015 Camaro 1LE SS
Track Cars: NASA Spec Ford Focus, 56 Corvette tube chassis

Statistics


Total Posts
Total Posts
769
Posts Per Day
0.32
Visitor Messages
Total Messages
3
Most Recent Message
03-22-2021
General Information
Last Activity
6 Minutes Ago
Join Date
11-17-2015

7 Friends

  1. blackops21 blackops21 is offline

    Enthusiast

    blackops21
  2. Bluesilvercoupe Bluesilvercoupe is offline

    Enthusiast

    Bluesilvercoupe
  3. Boba Fett Boba Fett is offline

    Enthusiast

    Boba Fett
  4. Firewater Firewater is offline

    VOA Member
    since 2020
    Arizona

    Firewater
  5. jpgunn123 jpgunn123 is offline

    Enthusiast

    jpgunn123
  6. Nemesis Nemesis is offline

    Enthusiast

    Nemesis
  7. pbnstevo pbnstevo is offline

    Enthusiast

    pbnstevo
Showing Friends 1 to 7 of 7