After looking around the internet I found out this part also fits challengers, Jeeps and other Mopar cars. Same part number retails for $200
Some of...
The same applies no matter where you cut or drill a hole was my point. Good tape job and a quality bit, the base of the stanchions are big enough to...
The underside support (dog Bone) had holes in it that was the template so I drilled from the bottom up with my pilot hole and drilled the finish size...
I could strap them to a pallet (or 2 separate ones)and you could have a freight service pick them up. It would probably cost $400-$700 hundred to go...
Mine started doing the same thing at Watkins Glen. Ended up being my clutch was at the end of its life. I just picked up an Nth Moto clutch cant wait...
I agree high-flow cats on stock exhaust get rid of the drone. Also when combined with the Prefix engine race tune with gurgle turned down is as good...