Search:

Type: Posts; User: AZTVR

Page 1 of 20 1 2 3 4

Search: Search took 0.47 seconds.

  1. Note that the 2014 may have a 10year powertrain...

    Note that the 2014 may have a 10year powertrain warranty if its VIN was included in the r28 "recall." The 2015 would not. You would need to confirm that with a dealer. Not all 2013 and 2014 were...
  2. Replies
    67
    Views
    1,460

    Take a look at the pivot point of the trailer...

    Take a look at the pivot point of the trailer bed. I do not think that raising the front of the trailer will reduce the bed's angle since the bed's pivot point is about at the trailer's axle which...
  3. Replies
    67
    Views
    1,460

    There is an 18 foot one listed in San Diego area...

    There is an 18 foot one listed in San Diego area Craigslist at a dealer in Oceanside, CA
  4. Replies
    67
    Views
    1,460

    Not exactly a tilt trailer; but, there is a...

    Not exactly a tilt trailer; but, there is a kneeling trailer that I have seen quite a few of at various California track events: https://www.futuratrailers.com/

    Jimglo usually has had a display...
  5. Replies
    191
    Views
    14,821

    Well, hopefully the buyer googled the VIN before...

    Well, hopefully the buyer googled the VIN before he bought the car, and bid accordingly. It appears that it was offered at Manheim in California around 10/11/2021
  6. Replies
    17
    Views
    351

    Although I installed the breather tube thing when...

    Although I installed the breather tube thing when I first bought my car, after reading advice in threads like this 15 years ago, I also cranked down the cap very tight. I always found it very...
  7. Yes, SOME self control on the part of the readers...

    Yes, SOME self control on the part of the readers of the forum.
    There is a theory that one could just not click on the clearly identified threads that are deemed undesirable. Like using some...
  8. Replies
    28
    Views
    422

    Same here. What I liked about using this was...

    Same here. What I liked about using this was that I could see the air as it was being expelled, bit by bit until no more came out, along with squeezing the upper hose. It gave me a good feeling...
  9. Replies
    1,339
    Views
    194,508

    This shows why a replaced engine won't devalue...

    This shows why a replaced engine won't devalue most Viper sales. Most people do not check unless they are buying an extremely low mile collector's display version.

    Carfax does not necessarily...
  10. Replies
    1,339
    Views
    194,508

    Did you verify that the car has the original...

    Did you verify that the car has the original engine ?
  11. I agree. There is hardly any information from...

    I agree. There is hardly any information from which to draw a conclusion other than a WAG. The one thing that I noted is that the fatality was of a regular driver/visitor at the track. So, at...
  12. Replies
    191
    Views
    14,821

    Here is a link to tie a newer thread with a...

    Here is a link to tie a newer thread with a little more information on TA 49, 1C3ADEAZ7EV200049 to this one: https://driveviper.com/forums/threads/29094-2014-Orange-TA-seems-like-good-deal
  13. Replies
    191
    Views
    14,821

    There is nothing better than drifting donuts in...

    There is nothing better than drifting donuts in your yard with your OTA Viper !!! https://youtu.be/dud5HI47uKU?t=1008 Posted a few days ago.
  14. Replies
    9
    Views
    357

    When I had an issue with the speedo being...

    When I had an issue with the speedo being intermittent when I first bought my 2002 in 2006, I traced it to a bad connection between the sub harness and the main harness, down around the front...
  15. The oil light is an oil pressure warning light,...

    The oil light is an oil pressure warning light, not an oil level warning light. There is no oil level sensor on any year Viper. When key is in ignition mode; but engine is not running, there is no...
  16. Replies
    23
    Views
    881

    So, how does one read that oil requirement chart?...

    [/QUOTE]



    So, how does one read that oil requirement chart? The component numbers do not add up to the Total AC System number. (I am guessing the "Line blown" has a meaning to AC...
  17. Replies
    12
    Views
    437

    Yours definitely appears to be an IPSCO unit, and...

    Yours definitely appears to be an IPSCO unit, and if you have any issues, contact Mark at IPSCO. He is very helpful and there is some further adjustability of the lever arm position not mentioned in...
  18. Replies
    12
    Views
    437

    Have you adjusted it per IPSCO's instructions? ...

    Have you adjusted it per IPSCO's instructions? Mine held adequately on a considerable slope; but, I wouldn't say that it was as good as the stock Gen 2. The instructions are posted on IPSCO's...
  19. Replies
    22
    Views
    823

    YES !!! The dipstick tube is not wiping oil off...

    YES !!! The dipstick tube is not wiping oil off of the dipstick. What is happening is the other way around. Oil in the tube is getting deposited on the dipstick above where the level of the oil is in...
  20. 2000 Chrysler Viper GTS R Ex Works Team ORECA

    I just randomly saw this car for sale ad today while searching for something else. I have no connection with the seller. I just thought that the photos in the ad were amazing and the car brings...
  21. Replies
    11
    Views
    606

    Since it fell off in your garage, I would guess...

    Since it fell off in your garage, I would guess that the prime suspects are: cat, mouse, or squirrel.
  22. Thread: ACR s at Mecum

    by AZTVR
    Replies
    21
    Views
    1,379

    Are you asking about income tax as a seller, or...

    Are you asking about income tax as a seller, or state sales tax as a buyer? The state sales tax would depend on the particular state that the auction was held in. The answer to the state sales tax...
  23. Replies
    38
    Views
    2,250

    I did not think that MGW made a short throw...

    I did not think that MGW made a short throw shifter assembly to fit a Gen 2; but, I do not know for sure. (I thought that it was too tall for Gen 2 fitment.) Others might know for sure.
  24. Replies
    10
    Views
    328

    Well, IMHO, the next step is to measure and...

    Well, IMHO, the next step is to measure and report the voltage at each of the nodes in the schematic, at the relay and the starter, with the ignition switch in the start position.
  25. Replies
    10
    Views
    328

    When the ignition switch is in the start...

    When the ignition switch is in the start position, do you measure 12V on both sides of the fuse providing power to the starter solenoid? Do you measure 12V on one pin of the connector that connects...
Results 1 to 25 of 500
Page 1 of 20 1 2 3 4