Search:

Yes

Driver and passenger? Both?

Any time the battery is replaced or you loose power the windows needs to be reset.

1. Get in close the door

2. Turn the key on

3. Run windows all the way down, stop when down, hold down...

Starter fixed it! Very hot today, many starts, all good.

Heads up the AC/Delco starter dose not have the locking electrical connector the the MOPAR unit has. I used a wire tie strap.

New...

Cable will be next if it's not the starter. So far it's good. Crank 10-12 times at the autocross, that's the problem.

Just finished, starts fine, the problem is when it's hot out and a 15/30 min drive. Then it's slow to crank. Dose seem to crank faster, RPM before it fires off seems higher.

Will report back in...

Big power line from the starter to the battery?

AC Delco, New not remanufacture, I can keep and rebuild my old MOPAR unit!

Cool I'll check it!

I am changing the starter tomorrow and I would like to clean the engine to frame ground strap. most of the time it is at the back of the block connected onto large bolt. Anyone know the exact...

Cost and weight, Now have a low cost CCM (under 3K) solution in place.

I'm just showing some options.

You could use a 1MM caliper spacer to move the pad to a wider arc.

That is one...

If it ever makes contact I'll address it then, with a cutoff wheel.

This setup is off right now as I converted the front to ACR CCM rotors. Still working the rears.

Changed battery, cleaned and install new ends on cables. Cranks fine when cold.

Starter Time??

Cost is low and rotors are light!
https://driveviper.com/forums/threads/29595-DBA5000-rotors-with-TA-pads

Volume is not pressure, if you put more volume into the same space you will get a pressure increase. If your pressure is to high (cold start/thick oil) the bypass in the filter will open and...

You can see the air in it. No under drive.. I will do the flush.

I would need a new fan motor and Rack if it's all dirty? Again only at high RPM. if I stay below 3500 RPM zero noise. I have been working hydraulics for 40 years and it seem like the system is...

I don't remember. It's like pulling air into the system at RPM.

New is under $100. Same pump used on RAM 1500 and Jeep's

Full, seems to be a lot of air in the fluid...

I have changed the pump 3 years ago. Only when I am above 4K. Using the ATF+4 fluid.

It all works fine, just loud! Sound like a super-charger...

What is the highest number I can get out of the stock setup.
Based on the tires I need another 1/2 degree front.

I have used custom bolts on other cars, making the slots in the frame longer to...

Start with the base tune, Scott will work with you to refine it. But nothing is better than dyno-time.

I live across the Mid Bay from you!

My 3.73 Mopar gear was from Summit.

https://www.summitracing.com/parts/dcc-p5007043

I went with wavetrac and 3.73. Khumo's and Cam Heads exhaust...
Moton Shocks 400/800 and 250PSI in the dampers.
1.7 front - .8 in rear for camber.

All work together, lots of help from...