Home › Forums › Gen III / Gen IV › Installing the front splitter on a Gen 4 ACR

Viewing 1 reply thread
  • Author
    Posts
    • LATAMUD
      Member
      February 21, 2016 at 10:45 pm
      Post count: 802
      #281266

      You can push the splitter up. If you want more pressure you could rivet it on then remove the bumper cover and press both pieces together. I see a lot of splitters removed with the covers as one with the 2 sided tape holding them together. I just don’t use the 2 sided tape and use screws instead of rivets. My splitter comes off a lot to do front end mods.

    • Shannon Whitehead
      Keymaster
      June 11, 2025 at 2:29 am
      Post count: 274799
      #22394

      I know that you use 3m double sided tape between the fascia and the front splitter but how do you apply pressure to both parts while it sets up?

  • Author
    Posts
Viewing 1 reply thread
  • You must be logged in to reply to this topic.